ANNUAL STAFF HOLIDAY (21 June - 6 July) - Orders placed will be processed on the 7th July

Size Guide

We are keen to help you get the best size first time and have provided individual sizing charts for each jacket, coat and waistcoat style. It is important to note that leather garments are crafted from tailored leather panels which do not contain elastic properties common to many modern day fabrics such as a jumper, stretchy top, tunic style top or loose fitting top. Therefore when selecting a size in a leather garment you should consider what your usual size is most typically in a jacket or a suit that does not have stretch properties, that is to say you should identify your jacket size and the size you most often buy or vary between (i.e. not a size you have managed to fit into on a very odd occasion which is not representative of your main wardrobe sizing).

Garment Lengths

Jacket lengths are provided throughout the range, this will be the centre back length excluding the collar. With regards to biker style and fashion style garments in particular we would suggest checking the jacket length if you are tall or long in the body, or desire a jacket that comes past the waistline by an inch or two. Most of the female models pictured here vary in height between 5' 4" to 5' 7". The male models pictured vary between 5' 11" and 6' 2" or 6' 3".

 

Garment Fit Styles

The fit style for each garment is listed as the third bullet point, this is to provide an indication of the additional room allowance over and above the 'to fit chest size' detailed. The fit style types listed and their meanings are as follows:

 

Fitted / Fashion Fitted - intended to provide a tight fitting fit, this typically narrows into the waist by 5 - 6 inches. Individuals of an average build desiring a semi-fitted fit that allows for a thin jumper and a little bit of additional room should typically order the bigger size that would vary to in a tailored jacket (i.e. if you vary between a size 10 to 12, you would order size 10 if a tight fit is desired with no room allowance, or size 12 for a smart semi-fitted fit). Individuals of a large build may need to order 2 sizes up. We would suggest checking your actual chest / bust , waist and tummy measurements. If the tummy or waist measurement is wider than the chest this garment style will not be suitable.


Semi-Fitted - shaped garment with room allowance for a thin top or thin fine knit jumper and to provide a smart fit. This style garment will narrow into the waist by 4 inches or so and the hem of the garment will be about the same width or just 1 inch or so slightly wider than the chest. If the waist or tummy measurement is wider than the chest / bust measurement this garment style is unlikely to be suitable if you wish to fasten the jacket.


Regular Fit - smart fit with room allowance for a thin knit jumper, provided the tummy and waist measurements are 2 and 4 inches narrower than the chest.


Comfort Fit - to allow comfort when wearing a standard jumper (not a chunky jumper), these garments tend to be straight cut. If the waist or tummy measurement is wider than the chest you will need to order the corresponding size to this measurement.


Generous Comfort Fit - to allow extra room for a fleece jacket or suit jacket. Some individuals will need to order 1 or 2 sizes down in these styles if they are of a slim or average build. If the waist or tummy measurement is wider than the chest you will need to order the corresponding size to this measurement.


Each sizing chart gives an indication of the approximate 'To Fit Chest' size across the top row as a initial guide.

When selecting a size from the chart and a range is given in the 'to fit chest' field (e.g. 38"- 40" chest), this is the approximate chest width that the size will fit based on a medium build and average height. The size will offer a regular fit on a 38" chest and a slim fit on a 40" chest. For those seeking a shorter length sleeve length we also offer a sleeve adjustment and tailoring service for garments within our range as well as a made to measure option across selected garments. If you are after a longer sleeve length then please state this in the 'comments' section of the order page and we will check sleeve length prior to order dispatch.

Where a size chart also details the average and approximate external dimensions of the leather garment, this is to give you an average indication of the maximum size the garment will be. The external dimensions are intended to enable comparison to one of your own jackets or coats that fits well. Also if the jacket, coat or waistcoat is padded then you will also need to allow for 1-2" loss in the external chest and waist width. That is to say that the jacket, coat or waistcoat will be a total 1" to 2" smaller on the inside circumference if it has a padded or quilted lining (e.g. 1" less if lightly padded lining, 2" less if thickly padded lining).

Please contact us if you would like assistance with sizing.

If you typically find it hard to get a good fit in the shops then please highlight this when you order.

E-mail: info@ukleatherjackets.co.uk

Tel:  +44 (0) 1299 382382

 

How to Check Your Size

1) Ensure your are wearing clothes of the the typical thickness to be worn underneath the jacket (please ensure you are not wearing a dressing gown or a thicker top than you would intend to wear under the jacket), ladies must be wearing their bra under their top. Please just breath normally and be relaxed (do not puff your chest out nor suck in your breath).

2) Hold the tape as high as possible underneath your underarms to capture the bottom of the shoulder blades at the back, keeping the tape high at the back bring the tape round to the widest part of your chest muscles which will require you to tilt the tape down at the front to the peak of the pectoral muscle.

3) If the waist or the tummy looks the same width as the chest or wider it would be wise to measure these also.

We do recommend that the person's up to date chest measurement is used when selecting the required size from the leather garment sizing chart. Where the stomach or abdomen area is larger / wider than the chest then this measurement needs to be used when selecting the jacket / coat size against the 'To Fit Chest Size' .

Further details are provided below if you wish to check garment lengths and, or require a specific sleeve length:

     (i)  Garment length is detailed on the full product page. The garment length excludes the collar and is measured in the centre of the back panel from the base of the collar stitch seam line down to the bottom of the jacket.

     (ii) Top sleeve length - this is the full length from the cuff of the sleeve up to the shoulder seam.



LADIES - Sizing Notes:

Please note that bra size does not generally equal chest size.

We do recommend that the person's up to date chest measurement is used when selecting from below sizing information. Please note that bra size does not typically equal chest size, hence it is recommended that an up to date measurement is taken. Furthermore, if the person's waist or abdomen area is larger than the chest, then this measurement needs to be used when selecting the required jacket chest size if the jacket is to be done up.

 

MEN'S - Sizing Notes:

Please note that suit / jacket sizes can vary between brands, hence why the up-to-date actual chest measurement at the widest point for the person that will be wearing the jacket can help in selecting the appropriate jacket size. Please note: if the person's waist or abdomen area is wider than the chest, then this measurement needs to be used when selecting the required jacket chest size if the jacket is to be done up.

 

GUIDANCE

Alternatively, if you are borderline between sizes and, or would like guidance on best size for you please add in the Special Instructions box on the order checkout page the below information:

  • Chest measurement - up to date actual chest measurement:
  • Waist measurement (at the widest point - very important if the jacket is to be done up):
  • Size usually taken

 

Alternatively you can provide measurments from a jacket or coat that fits you well. The garment needs to be zipped / buttoned up and laid flat on a flat surface (e.g. table or floor). Please check the garment is completely flat (check it is not rippled on the underside) before any measurements are taken.

1) Flat Chest - from underarm to underarm (to provide the width of the jacket when completely flat):

2) Flat Waist - edge to edge measurement across narrowest point:

3) Flat Hips - applies to coats and long jackets - width across the widest part of the hips:

 

Wrong Size?

If the leather is just a little tight or snug,  we would suggest sticking with it as the leather, like a shoe, will give a little over time.

You will require a new size if the garment is noticeably uncomfortable, and/or difficult  to ‘do up’.

Each increase in size will typically see a 2 inch gain across the chest and waist, the shoulder  only widens very marginally by a  ¼ inch on each side and the sleeve  length may increase by about ¼ to ½ of an inch.

In special circumstances you may be between two sizes, which we may be able to you help with. If for example you need to go up a size in the chest but wish the shoulder and sleeve measurements to remain the same please let us know when requesting the exchange and we may, after checking existing stock, be able to find a suitable replacement.